DT-ASM-005 ASSEMBLY STEP 5 - Press heat sink into motor housing

The dashed line marks the housing edge for rough alignment; L is the depth measured down to the heat sink face.

Tools:

• Heat sink press tool (250010011)
• Digital caliper

Consumables:

• Silicone spray

Installing parts:

• Heat sink (040050002)

Procedure:

1. Apply a thin coat of silicone spray to the outer diameter of the heat sink to ease installation.
2. Insert the heat sink into the motor housing.
3. Press the heat sink until it reaches L = 42,3 mm from the top edge of the housing.

CAUTION

Check the heat sink depth with a digital caliper. Adhesive is no longer applied at this step.